MONSTERMOUNT MB-3105, Installation Instructions Manual

ENG

7

STEP 3

Final Assembly

1. Make sure the safety stops are in the proper location on each mount arm, as 
shown in the illustration (see Fig. 8 below).

2. With the help of another person, carefully lift your display and place it on the 
wall plate. 

Do not release the display until the mount arms have securely 

hooked onto the wall plate.

3. Tighten the safety stop located at the bottom of each mount arm to prevent 
the display from being lifted from the wall plate.

IMPORTANT!

 The safety stops must be used at all times to prevent the display 

from being accidentally knocked from the mount.

OPERATION AND ADJUSTMENT

1. To change the tilt angle of your display, hold the display firmly with one hand 
and rotate one of the tilt adjustment knobs towards the display (away from the 
wall) to unlock the tilt. 

Make sure you rotate the knob fully.

 Carefully move 

the display to the desired position, and then return the tilt adjustment knob to its 
original position to lock the display in place. 

Do not release the display until 

the tilt is locked.

2. Periodically clean your mount with a dry cloth. Inspect all screws and hard-
ware at regular intervals to ensure that no connections have become loose over 
time. Re-tighten as needed.

Fig. 8

Safety Stop