© 2011 Monte Carlo Fan Company
2/9/2012
3
Before you begin installing the fan, Switch power off
at Service panel and lock service disconnecting
means to prevent power from being switched on ac-
cidentally. When the service disconnecting means
cannot be locked, securely fasten a prominent warn-
ing device, such as a tag, to the service panel.
1
Before installing this fan make sure the outlet
box is properly installed to the house structure.
To reduce the risk of fire, electric shock, or per-
sonal injury, mount to outlet box or supporting
system acceptable for fan support.
(Mounting must support at least 35 lbs.)
2
4
Remove cotter pin from downrod, and
save for later use.
5
Place canopy over downrod.
6
Loosen the 2 set screws until the do
not protude into the inside of the
yoke.
Use metal outlet box suitable for fan support and
use only the screws provided with the outlet
box
(must support 35 lbs). Before attaching fan to
outlet box, ensure the outlet box is securely fas-
tened by at least two points to a structural ceiling
member ( a loose box will cause the fan to wobble).
Remove the two outlet box screws provided with
the box, aligning the holes of the mounting bracket
with the holes of the outlet box. Re-install the 2
outlet box screws securely.
3
Place yoke cover over downrod.
7
8
Thread the leadwires and safety
cable through the downrod.
9
Insert downrod into the yoke on top
of fan body. Align the hole in the
downrod with the hole in the yoke.
Insert cotter pin through yoke and
downrod until point appears on the
other side
