Attach glass by locating dimples in
light fixture with the groves in glass
and twisting clockwise till tight.
30
Install 3 screws and fiber washers to back
side of blade as shown.
Tighen screws securely. Repeat this
process 4 more times until all blades are
assembled.
27
28
Hang fan from mounting bracket by
the hands free “S” hook in hardware
pack into a closed hole on the edge
of the canopy and over bracket..
Note: For Canadian mounting refer to
Step #10.
24
Remove side covers to canopy.
20
23
Remove the all thread studs from the
lower part of the mounting bracket. Install
2 screws that align with the “L” shape
holes in the canopy into the mounting
bracket. (see step 15)
Screw for “L”
shape slots
Screw for “L”
shape slots
“L” shape
slots
Place canopy on top of the fan motor allowing the
yoke to pass through the large hole in the center
of the canopy. Align the 3 larger holes around the
center hole with the 3 screws already installed in
the fan. Install 3 flush mount screws removed
previous step into smaller holes and tighten
securely.
22
Canopy
Center
Hole
Larger
holes
Smaller
holes
Lift fan to mounting bracket, aligning the “L”
shape holes with the scresws on the mount-
ing bracket. Turn the fan clockwise to lock
in position. Install the other two screws and
tighten securely.
25
Remove 2 screws in yoke. Remove 3
screws (every other screw) from top
of fan.
21
Swing blade holders out and align hole with
arrow on blade holder with hole in blade with
arrow. Make sure that the side of the blade
that has the sticker this side up is facing
upward.
26
Pass leadwires and safety cable through
the canopy.
Steps 19-25 for flush
mount installation skip to step 26 if
using the downrod.
19
FFlluusshh M
Moouunntt IInnssttaallllaattiioonn
install 1 x 100 watt halogen bulb with socket
type E-11. Do not touch bulb surface as oily
residue from skin can cause the bulb to
explode.
WARNING: Over lamping the fan will
result in the fan lights shutting down
until the proper wattage of bulbs are
installed. Reset the lights by turning off
the wall switch, breaker,or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
29
