Tighten screw on arch hub into
downrod to hold in place.
21
Tighten set screw to hold ball in
place.
26
Raise fan with downrod assembled to
the ceiling bracket and hang fan
assembly. Be sure to rotate the
downrod ball so that the notch in the
bracket engages the slot in the ball.
29
Set dip switches on the Remote Transmitter and Remote
Receiver to the same settings. This must be done so the
units will communcate properly. If you have other fans you
can set to control from one transmitter by setting both
receivers the same as the transmitter. If you have more
than one fan with remote. You can set the dip switches to
different positiosns to have seperate control.
Remote Transmitter Dip swtiches
Remote Receiver Dip switches
28
Fan and light kit combinations over 35 lbs,
in both flush and downrod mode the safety
cable must be installed into the house struc-
ture beams using the 3” lag screws,washers,
and lock washers. provided. Make sure that
when the safety cable is fully extended the
lead wires are longer than the cable and no
stress is placed on the lead wires.
30
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Install lower foot of arch arm with
screws to fan upper housing.
19
Install arch arms to arch hub using
screws removed step 18.
20
Tighten set screw to hold ball in
place.
27
Place ball on downrod. Replace pin
removed earlier and pull ball up so that
the pin fits in the notches in the ball.
25
Install arch hub cover onto downrod.
22
Install canopy onto downrod.
23
Thread leadwires and safety cable
through ball.
24
