© 2011 Monte Carlo Fan Company
4/20/2012
5
Loosen 2 screws and remove 1 screw
and save.
27
Attach blade assembly to motor
using the motor screws and washers
provided. Tighten screws securely.
26
Install 3 screws and washers per
blade and tighten securely. Repeat
for all 5 blades.
25
Place the gasket onto the blade
bracket as shown above.
23
Warning: Only blades that come
with the fan are accepatable for
installation.
Place blade onto blade bracket with
gasket.
24
Make sure that all exposed wiring is
secured inside wire nuts. Note: Wires
from house may vary in color and
may not include ground wire. After
wiring is conplete, gently push wires
into junction box with wire nuts
pointing upward. Refer to point 3 of
safety tips.
21
House
Fan
Black
White
Green
Black
White
Green(downrod)
Green(Bracket)
Make wire connections to power source using
wire nuts provided. Make sure that no filiments
are outside of the wirenut. After making the
wire connections, the wires should be spread
apart with the grounded conductor and the
equipment-grounding conductor on one side of
the outlet box and ungrounded conductor on
the other side of the outlet box.
20
For Canadian installation and for USA fan and
light kit combinations over 35 lbs, in both flush
and downrod mode the safety cable must be
installed into the house structure beams using
the 3” lag screws,washers, and lock washers.
provided. Make sure that when the safety cable
is fully extended the leadwires are longer than
the cable and no stress is placed on the lead-
wires.
19
Safety cable installation
Safety Cable
Lag Screw
safety
cable
3” lag
screw
lock
washer
washer
Loosen one and remove one preassem-
bled screw from mounting bracket. Save
screw. Lift canopy up, aligning its keyhole
slot with the preassembled screw on
mounting bracket and twist clockwise to
lock in place. Re-install the removed
screw and tighten all screws securely.
22
Summary of Contents for 5DCR60XX Series
Page 10: ......
