© 2013 Monte Carlo Fan Company
11/15/2013
6
Remove switch cap housing from fan.
Remove the plug of fitter. Install
switch cap housing to light kit by
turning clockwise to tighten.
28
Install keeper nut over lead wires.
29
Tighten keeper nut onto threaded
pipe from the light kit.
30
Install 2 x 13 watt GU24 base CFL bulbs. Bulbs
Included.
WARNING: Over lamping the
fan will result in the fan lights shutting
down until the proper wattage of bulbs
are installed. Reset the lights by turning
off the wall switch, breaker, or by remote.
Replace bulbs with the correct wattage
bulbs, turn the power on.
31
Locate blue and white wire from the fan
marked “For light kit”. Connect blue from fan
to black from light and white from fan to white
from light by pushing connectors together.
32
Attach switch cap to fan by lining up
2 slot ear holes and 1 screw hole and
twisting cap. Then tighten the 3
screws.
33
Remove nut and save for next step.
27
Remove finial nut, finial cap, hex nut
and rubber washer from fitter and
save.
34
Attach the glass to the light fixture.
Install the rubber washer first and
then the hex nut to the glass to se-
cure in place.
35
