Monte Carlo Fan Company 5YK52 Series, Owner'S Manual And Installation Manual

6

© 2018 Monte Carlo Fan Company

10/2018

18

19

21

22

20

Install 2 of the screws to the side panel of 

mounting bracket corresponding to the 

open slotted holes on the canopy upper 

rim, screws provided. Remove the thread 

studs from the lower part of the mounting 

bracket.
Lift fan to mounting bracket, aligning the 

“L” shape holes on canopy with the 

screws on the mounting bracket. Turn the 

fan clockwise to lock in position. Install 

the other 2 canopy mounting set screws 

from the hardware pack and tighten all 

screws securely.

Install blade bracket with blade by 3 blade 

screws and washers

provided. Tighten 

screws securely. Repeat this process for 

remaining blades.

Remove shipping stabilizers from motor 

assembly.

Install the blade assembly to motor using 

the preinstalled screws. Tighten screws 

securely. Repeat this process for 

remaining blade assemblies.

Loosen 2 and remove 1 preassembled 

screw

 from top plate of switch housing.

Connect the quick connectors from fan 

and switch housing. Make sure quick 

connectors are clasped firmly.

Install the switch housing onto the top 

plate, aligning the keyhole slots on 

the switch housing with the 

preassembled screws on top plate and 

twist it clockwise till lock. Reinstall the 

set screw removed in step 21 and 

tighten all screws securely.

Install fan pull chain to preassembled pull 

chain on fan. Pull chain provided. 

Setting the reverse switch in the left hand 

side will result in downward airflow and 

setting the switch in the right hand side 

will result in upward airflow.

Note

: Reverse switch must be set either 

way completely. If the reverse switch is 

set in the middle position, fan will not 

operate.  

Blade bracket

Blade

Shipping stabilizers

Reverse switch