If a reversed polarity warning is indicated, DO NOT USE
the shore power source. Immediately turn off the power
source on shore and disconnect the shore power cord.
Reversed polarity is a dangerous and potentially lethal
condition which may cause shock, electrocution, or
death.
Main AC Breaker
– Switches the entire AC system “ON” and “OFF.”
This allows you to check for proper voltage and polarity immediately
after shore power cord connection has been made, before individual
circuits are enabled.
Individual Circuit Breakers
– Allow you to manually enable or inter-
rupt a circuit by flipping the switch “ON” or “OFF,” and they also pro-
tect the system receiving the AC load by automatically breaking the
circuit in cases of shorts or overloads.
Never reset a breaker which has been automatically
tripped, without first discovery and remedying the cause
of the problem.
If your boat is equipped with a generator, the Generator Control
panel contains the starting/stopping controls for the generator as well
as the controls for switching between Shore Power and Generator.
Notice
Read the generator owner’s manual before operating
the generator for the first time. The manual contains
important operation and maintenance information.
Whenever operating the generator, you must first operate the engine
compartment blower for at least 4 minutes prior to starting, and con-
tinuously during generator operation to remove dangerous gas or
vapor.
The blower must be operated for a minimum of four min-
utes before each time the engine is started. In addition,
the blower should be operated continuously when at idle
or slow speed running. Failure to operate the blower can
cause an explosion.
Notice
Models equipped with a diesel engine powered genera-
tor may have a PREHEAT switch used during starting.
!
WARNING
!
!
CAUTION
!
WARNING
!
SHIP SYSTEMS
11-4
Summary of Contents for 268 SC Sport Cruiser
