STEERING CONTROLS
All boats have a tendency to wander somewhat at slow speeds. A natural
reaction to this effect is to steer the boat back and forth in an attempt to
compensate for wandering. Invariably, the compensation will result in over-
steer and only worsen the effect. Keep the steering wheel in the center
position, the boat will wander back and forth somewhat, but the overall
course will be a straight one.
The steering system must be in good operating condition for
safe boat operation. Frequent inspection, lubrication, and
adjustment by your dealer is recommended.
STOPPING
1. Slowly bring throttle control to the idle position and the shift control to
the NEUTRAL position. Bring the trim tabs to the UP position and the
outdrives to the IN position accordingly. If the boat has been driven for
a long period of time at high speed, allow the engine a 2-3 minute
cool-down period at low idle.
2. Turn the ignition key to the OFF position.
3. If any problems were encountered during the outing, have the boat
inspected by your dealer and request any necessary repairs before the
next outing.
Do not use the engine stop switch for normal shutdown. Doing
so may impair your ability to re-start the engine quickly or may
create a hazardous swamping condition.
End of Day Shutdown
●
To prevent marine growth from accumulating on the hydraulic cylinder
shafts, make sure trim tabs are UP and outdrives are in the full IN
position.
●
Lock ignition key switch and remove ignition keys.
●
Stow and secure all equipment.
●
Pump bilges dry with manual switch. Leave on AUTO when finished.
●
Close all inlet seacocks and fuel valves.
●
Use fresh water to flush head and engines.
●
Inspect boat for damage.
●
Clean any spills, stains, or moisture from boat. Inspect and clean sea
strainers.
●
Turn battery select switches to OFF.
!
CAUTION
!
WARNING
!
OPERATION
4-5
Summary of Contents for 268 SC Sport Cruiser
