To use the hot water heater:
1. With fresh water tank filled and pump “ON” or city water connection
operating, turn HOT WATER HEATER breaker “ON.”
2. Turn on one of the hot water faucets to purge any remaining air from the
hot water system.
Note
Some hot water heaters are equipped with a high temperature
limit switch to protect the heating elements should the heater
be activated without water in the tank. If for any reason the
system does not operate, turn the hot water heater breaker
“OFF” and push the reset button on the heater.
Fresh Water System Maintenance
The following maintenance actions should be performed monthly to keep the
fresh water system clean and sanitary:
●
Drain the fresh water tank completely (using all faucets, showers, etc.).
Refill tank with at least 20 gallons of clean, fresh water and drain again.
●
Clean fresh water pump inlet filter screen (if equipped).
●
Replace fresh water system filter(s) (if equipped).
●
Clean city water inlet strainer (if equipped).
●
Flush city water system (using all faucets, showers, etc.).
SANITIZING THE FRESH WATER
SYSTEM
If water in the tank has been allowed to stagnate and you suspect that the
fresh water system may be contaminated, sanitize the system. To sanitize:
1. Drain the fresh water tank completely (using all faucets, showers, etc.).
2. Mix a solution of 1/4 cup household bleach to 1 gallon of water for every
15 gallons of tank capacity. Pour the solution into the fresh water tank.
3. Fill the tank with clean, fresh water.
4. Turn fresh water pump “ON” and bleed air from all faucets, showers, etc.
5. After approximately 3 hours, drain the system completely.
6. Flush the system with one full tank of water.
7. Fill tank with clean, fresh drinking water.
11-13
SHIP SYSTEMS
Cruiser
Cruiser Section 11 7/21/08 10:05 AM Page 11-13
Summary of Contents for Cruiser 256
Page 1: ...CRUISER BOATS OV VNER S MANUAL B O A T S ...
Page 48: ......
Page 76: ......
Page 80: ......