ELECTRODE SPARK ADJUSTMENT
CAUTION: Spark can cause small shock. Do not leave
fingers on or near electrode wire while engaging igniter.
• Electrode wire should be approximately 1/8” from gas
exit hole in burner. Carefully adjust wire if required.
5
Left
side
slot
Burner screw
Right
side
slot
Electrode
Locking
Indents
A
Outer Shell
Liner
Liner Lip
Disconnect wire
DISASSEMBLY & RE-ASSEMBLY
• Lift radiant plate up & out of left slot (see B) and remove by sliding it out
of right slot (see C).
• Remove burner screw (see B) and remove burner. Check burner for grease
residue or spider webs that may obstruct gas flow. CAUTION: WHEN
REPLACING BURNER, CUT SLOT IN BURNER MUST FACE DOWN.
• To remove liner from outer shell you must disconnect the electrode wire
(see D). First remove the two screws on valve chamber (see D) and remove
the cover plate. Gently pull wire off connector (see D). It is not necessary to
remove electrode from liner.
• Remove Lid and liner by removing hinge screws and lock nuts with 3/16”
hex key wrench (supplied) and 1/2” wrench or pliers. CAUTION: LOCK NUTS
MUST BE INSTALLED WITH LOCKING INDENT MARKS SHOWING (see E).
IMPROPER INSTALLATION WILL DAMAGE THE HINGE SCREW AND LOCK NUT.
• Lift liner out of outer shell by lifting up on liner lip on back side of liner
(see F). When replacing liner, be sure top lip of liner installs over top edge
of outer shell (start with corners of lip and work in).
• Inspect burner, remove any obstructions.
• Clean as indicated in Maintenance (page 6).
• To re-assemble, reverse the procedure.
B
C
D
Screws
E
F
Electrode
