14
15
1
•
888
•
557
•
3848
Wards.com
How to Use
Control Panel Functions
1. After the unit is properly installed and plugged in, press the power button to turn ON.
2. Press the mode button to select desired setting:
• Energy Saver:
The fan will automatically turn off when the compressor stops.
When the compressor starts again, the fan will turn on.
• Dry:
Unit acts as a dehumidifier to pull moisture out of the air.
• Fan:
The fan runs, but the condenser does not.
• Cool:
When the temperature of the unit is set colder than the air temperature
of the room, both the compressor and fan will run. But when the room temp
becomes colder than what is set on the AC, only the fan will run.
3. If fan mode is selected, press the speed button to choose low, medium or high
fan speed.
4. If cool mode is selected, use the time/temp buttons to select desired temperature.
The range of settings is 64
–
90
˚
F.
5. Use the air direction control levers to aim the stream of cool air up/down and left/right.
How to Use
(cont’d)
Remote Control
1
2
3
4
5
6
7
8
9
10
11
12
Remote Control Functions
1.
Signal transmission - Point the remote control at the air conditioner. When
the signal is received, a beep will sound.
2.
Cool button - Turn on cooling mode. Set the temperature using the +/- buttons.
3.
Dry button -Turn on dehumidifying functionality.
4.
Fan button - Use to vent the inside air through the unit to the outside.
5.
Energy Saver button - Use to start or stop Energy Saver mode, which is only
functional when cool mode is ON.
6.
ON/OFF button - Press to start or stop operations on the unit.
7.
Timer button - Use this button to set the number of hours (up to 24) the unit
should run continuously until automatically shutting down. To set the timer,
press the timer button, then use the + and - buttons to set the number of hours.
Pressing the timer button when the timer is in use will turn the timer off.
8.
Filter Reset button - When the check filter LED is illuminated, clean the
filter and then press this button to turn off the LED.
9.-11. The Low, Medium and High Fan buttons - These buttons will set the fan speed.
The fan will circulate the air in the room, but the condenser will not run.
12.
Increase (+) and Decrease (-) buttons - Use in conjunction with the timer
button for increasing/decreasing the time or with the cool mode for setting
the temperature.
Things to keep in mind regarding the remote control:
• If the air conditioner does not beep, letting you know that the signal has been
received from the remote, check the batteries.
• Do NOT place the remote on or near heat-emitting objects, such as a radiator or
electric blanket.
• Do NOT put the remote where the sun can shine on it.
• Do NOT expose the remote to water or other liquids.
• Do NOT put heavy objects on top of the remote.
• Avoid accidentally dropping the remote.
Battery Replacement
1. Turn the remote over and slide the battery cover in the direction of the arrow.
2. Replace batteries.
3. Slide cover back into place, making sure it is securely closed.
