Page 32
XG0514-150204
I-Series Indoor Gas Fireplace
Installation
Speckled Stone Installation
If your fireplace has already been in operation, disconnect the gas
and electrical supply, remove the door and safety barrier.
The driftwood log and speckled stone option is a beautiful way to
dress up your new fireplace insert. Installation of the stones and
logs need to be down in a precise way so that the performance of
your appliance is not altered. Follow these instructions for years
of trouble free operation.
1). You will have 6 bags of speckled stones with your package.
Figure 90 Sec.4
2). Empty the bags of stones into a box and GENTLY mix them up.
Figure 91 Sec.4
3). Place a row of stones front and back of the burner, below the
burner lip.
4). Fill one layer of stones over the remaining screen/burner area.
Figure 92 Sec.4
Figure 93 Sec.4
5). Now carefully place 2 rows of stones along the burner rims so
that 1/2 of the stone is sitting on the stones below and 1/2 of the
stone is resting on the lip of the burner alternating sides.
6). WARNING: A close up picture of the pilot area shows that NO
stones are placed over the pilot assembly or directly in front of
where the pilot flame carries over to the burner. Any exception to
this may result in unfavourable lighting of your appliance, or the
durability of the pilot and/or burner.
Figure 94 Sec.4
Figure 95 Sec.4
