Page 50
XG0514-150204
I-Series Indoor Gas Fireplace
Maintenance
12).
Install both new Blowers. Secure the Wire Harness with the Zip
Straps shown in the 2 pictures below.
Figure 22 Sec.6
1
3).
At this point, if you want to test the Blower operation, do so
with the Gas Supply turned off or disconnected. To test the Blower
operation, you will need to re-connect the electrical supply temporarily.
Disconnect the Electrical Supply after testing the Blowers.
Figure 23 Sec.6
14).
Re-install the Outer Shell Rear panel.
15).
You will need to replace the Flue Collar Plate Gasket prior to
re-installation into the cavity.
Figure 24 Sec.6
16).
Replace the Flue Connector Plate Gasket.
17).
Re-install the unit into the Cavity. See the section on Vent
Connections.
18).
Re-install the Face Plate Panels. See the section on Setup.
19).
Re-connect the Electrical Supply.
