XG0222
13
Installation
Figure 8.b.b
Included Restrictor plates
Figure 8.b.c
Restrictor plate Installation
Restrictor plate Installation
Under no circumstances can Montigo flex venting be cut to
accommodate an installation. Use an alternative length to complete
your vent run.
NOTICE
Section 3: Venting
The termination location MUST be selected such that it is the highest
point in the venting assembly. It should also be selected such that it
provides the shortest vent run possible. Should it be impossible to ensure
that the termination is the highest point or should it be impossible to
meet the venting guidelines laid out below please contact your Montigo
dealer to discuss power venting options.
Notes For Planning Venting:
Included Restrictor plates:
1" Baffle
1.5" Baffle
1.75" Baffle
The distinction is supplied with 3 different sized restrictor plates to
improve flame efficiency. The size of restrictor used largely depends
on the number of elbows used in the vent run, as well as vertical rise.
Lengthy vertical runs without elbows would generally require the 1.75''
restrictor. Shorter runs, or multi elbow installations would use the 1.5''
or the 1'' restrictor.
• Venting originates from the top of the unit.
• Venting can terminate through the roof or exterior wall.
•
For a detailed diagram of allowed termination locations, see
Appendix A.
•
Once the termination location has been established refer to the
appropriate section for installation details.
•
For Heat Shield requirements see Section 3-3-3.
