27
Installation
xg0227 - 112718
Removing the Screen
Grasp each top outer corner of the screen with your thumb and finger
and pull towards yourself. when the upper screen studs are free, lift
the screen at an angle from the lower slots from which the screen
bottom tabs are held. Place the screen in a safe place.
To Install Screens
Hold the screens at an angle away from the fireplace, and locate the
screen bottom tabs at the lower corners of the screen. Place the screen
into the Screen Tab Receptacles in the lower section of the fireplace.
Make sure the tabs and screens are lowered all the way down into
the Screen Tab Receptacles on the fireplace. Then, push each Upper
screen stud on the top corners of the screen into the upper screen
Stud Receptacles in the fireplace.
Replacement Screens
For replacement part order numbers, please refer to section
"Replacement Parts"
Section 7: Screen Installation and Removal
Any safety screen, guard, or barrier removed for servicing an
appliance, must be replaced prior to operating the appliance
figure 19.
Lift out the Retaining Tabs and screen
figure 19.b
Screen Installation and Removal
Glass doors on gas fireplaces are extremely hot while the fireplace is
on and remain hot even after the fireplace has been turned off. Safety
screens are mandatory and can reduce the risks of severe burns.
Please keep children away from the fireplace at all times.
cautioN
Notice
Screen Bottom
Tabs
Screen Tab
Receptacles
Upper Screen
Studs
Upper Screen
Stud Catch
Left Side Detail
Left Side Detail
Removing / Attaching
The Safety Screens
To Remove the screen(s)
Simply grasp each top
outer corner of the screen
with your thumb and
finger and pull towards
you. Once the upper
Screen Studs are free, at
an angle, lift the screen
from the lower slots in
which the Screen Bottom
Tabs are held. Place the
screen in a safe place.
To Install the Screen(s).
Holding the screens at an
angle away from the
fireplace, locate the
Screen Bottom Tabs at the
lower corners of the
screen into the Screen
Tab Recepticles in the
lower section of the
fireplace. Make sure the
tabs and screens are
lowered all the way down
into the Screen Tab
Recepticles on the
fireplace. Then push each
Upper Screen Stud at the
top corners of the screen
into the Upper Screen
Stud Catchs in the
fireplace.
DWG. NO.
MATERIAL
DIMENSIONS ARE IN INCHES
FRACTIONAL
TWO PLACE DECIMAL
THREE PLACE DECIMAL
ALL BENDS ARE ASSUMED
UNLESS NOTED
OTHERWISE.
DATE
NAME
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
Y:\Products\Residential Products\H38DF-PFC\H38DF-PFC
November-27-14 10:40:05 AM
SCALE
PC
A
11/25/2014
upper screen
studs
screen bottom tabs
screen tab
Receptacles
upper screen
stud catch
