28
Installation
xg0227 - 112718
1
Door buckles
Fixed
panel
Fixed
panel
Door Latch Hook
Door Latch Slot
Hand-hold
2
3
4
Fixed
Panel
STEP 3:
Firmly grasp handhold end
of door buckle tool and
place the machined end in
the slot under door frame.
(as shown)
STEP 2:
locate door buckles
STEP 1:
Remove the horizontal
valve blind by placing
fingers in both finger holes,
then pushing away from
you and lifting out. Place it
aside during maintenance
or cleaning.
Install in reverse order.
TOOLS REqUIRED:
DOOR BUCKLE TOOL
STEP 4:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), then pull
toward you.
STEP 5:
Pull hard if necessary to
release the spring tension.
(caution: the latch springs
back with force, hold the
tool securely).
STEP 6:
Remove the tool from
the latch slot. ensure the
latches are hanging freely,
the hook end is released
from the bottom of the
door. (Repeat all steps for
the remaining latches).
STEP 7:
grasp the door on either side, usually midway and lift upward,
lift the door carefully up and away from the front of the fireplace.
Place the door aside in a safe place while maintenance and / or
cleaning is being performed.
Removing the door
the doors are removed in a few simple steps. Follow these below to
remove the horizontal access panel, unlatch the door buckles and,
remove the door. Replace in reverse order.
Reinstalling the door
to install the door, hook the top edge of the door frame into place.
lower the door into position and follow the previous steps shown in
reverse order.
Section 8: Installing & Removing the Door
when reinstalling the door(s), always make sure all door buckles are
properly hooked and fully engaged.
figure 20.c
Locate door buckles
figure 20.b
Removing and installing the Horizontal Access Panel
figure 20.a
Door buckle Tool
figure 20.d
Locate door latches
figure 20.e
Pull door latches
figure 20.f
Lift the latch upward
figure 20.g
Lift the door up and out of the fireplace frame
figure 20.h
Removing and installing the glass doors.
WarNiNg
door buckles (PRc shown)
