Page
EP8-5 Modular Series Fireplace
XG0302C
Installation
Logset Installation
EP28-2LB/ -MB Logset
These models are supplied with two logs. To install, simply place the
back log's rectangular shaped extension into the log mounting slot
located on rear wall of the burner assembly. Place the front log onto
front log slots as shown below
.
Figure 8. Installing the -2LB/ -MB logset.
EP28-4LB Logset
This model is supplied with four logs. Install the bottom logs by fol-
lowing the instructions for the EP28-2LB. To mount the top logs, place
them in their mounting grooves as shown below.
Back Log
Front Log
Figure 9. Installing the -2LB logset.
Log 'D'
Log 'C'
Log 'B'
Log 'A'
EP28-S2 Logset
This model is supplied with six ceramic fibre logs. Unpack the logs
and handle them very carefully.
Place the Back log onto the back log rest as shown below in figure 9a.
The log has lip on the bottom which fits into the slot on the log rest.
Place the Front log onto the front log rest as shown in figure 9a.
Center the log from side to side, and push it against the back of the
log rest. Carefully push the log onto the metal spikes on the log rest.
Place the top logs in position as shown in figures 8b and 8c.
Start the fireplace. If the flame appears satisfactory, replace the glass
door and door cover.
Figure 9a. Positioning for the front and back logs.
Back log
Left log
Right log
Front log
Center logs
Figure 9b. Proper top log placement (top view).
Back log
Left log
Right log
Front log
Center logs
Figure 9c. Log placement as seen from the front of the stove.
