Page 8
H-Series BF Gas Fireplace
Part No. XG0145
Installation
Log 'D'
Cautions:
■
If logs are not placed properly, excessive sooting
will result.
■
The surface of the logs will crack due to the heat from
the flames. This is a normal occurrence.
Installing the Log Set
Installing the Logs:
The
H-Series BF
is supplied with four ceramic fibre logs and a ceramic
fibre logset base. Unpack the logs and handle them very carefully.
3.
Place the bottom left and right logs as shown below in figure
14d.
4.
Place the top left and right logs as shown in figure 14e.
1.
Remove the glass door.
2.
The base log is factory-installed, as shown below in figure 14b.
Figure 14a.
H-Series BF's five piece logset.
Figure 14b.
Base log placement.
Figure14d.
Bottom left and right log placement.
Figure 14e.
Top left and right log placement.
Base Log
Bottom Left Log
Bottom Right Log
Top Left Log
Top Right Log
Base Log
Bottom Right Log
Bottom Left Log
Top Left Log
Top Right Log
5.
Start the fireplace. If the flame appears satisfactory, replace the
glass door. If the flame does not appear satisfactory, double-
check the air inlet and exhaust outlet pipe to ensure that they are
unobstructed.
Air Inlet Ports
Ember Chips
3.
Arrange the ember chips on top of the burner tray. Care should be
taken when placing the ember chips, as blocked burner ports may
cause an incorrect flame pattern, carbon deposits and delayed
ignition. Also, the chips must never be placed in a way that obstructs
any of the air inlet ports, located at the rear of the burner, as shown
in figure 14c.
Figure 14c.
Ember Chip placement.
H34BF
