H36PVN Power Vent Indoor Gas Fireplace
Page 20
XG0649 - 031511
Installation
Section 5: Wiring
The Fireplace A/C power and Power Vent harness's must be installed
before completing the installation of the
H36PVN
Fireplace. These
connections are made from the RH-Side of the fireplace,
Figure 12
through
Figure 12f
.
Figure 12. Incoming A/C Power , (connect per. Local Codes).
Figure 12a. Remove Exterior Access Cover.
Install the Power Vent connections as described
below:
Step 1.
Remove the exterior Access cover, shown
Figure 12a
.
Step 2.
Locate all the Power vent connections & ports,
Figure 12b
.
Figure 12b. Locate Power vent connections.
Note: To access the fireplace electrical connections from the
firebox follow the procedures described in
figure 22 through 26
.
Power Vent,
& A/C Access
Cover
Power Vent,
Communica-
tion port.
Power vent communi-
cation conduit, A/C
connection port
Incoming A/C
Power Connection
Step 4.
Place the cover plate on the Conduit, then tighten the strain
relief nut onto the threads protruding through backside of cover plate,
Figure 12e
.
Step 3.
Remove the Power Vent communication port cover from
cabinet, (as supplied)
Figure 12c
.
(
Philips head screwdriver
required
).
