H*38DF ST Indoor Gas Fireplace
Page 18
XG0207 - 150204.1
Installation
Figure 15.
RHS8 Installation. (Install by sliding over vent pipe where it passes
through the combustible construction).
Figure 16.
RHS101 Installation. (Install by sliding Outer Section over vent pipe
where it passes through the combustible construction.
Figure 16a.
Heat Shield. After sliding the outer section in place.
Figure 15a.
RHS8 Installation. (
Minimum requirements
).
Section 3-3-3: Heat Shields
Installing a Wall Mounted RHS8 Heat shield
The RHS8 Heat shield
CANNOT
be used
WITHIN
36" horizontal or
46" vertically
of the fireplace, (see
figure 15a)
. For applications within
these dimensions the RHS101 Heat Shield
MUST
be used.
To install the RHS8, frame an opening in combustible construction,
Figure 15
below. Slide the Heat shield in place over the vent pipe
which attaches to the fireplace. After the fireplace and vent pipe has
been installed, clearances should match the dimensions in
Figure 15
Installing a Wall Mounted RHS101 Heat shield.
The RHS101 Heat shield
MUST
be used where the RHS8 Termination
(
Figure 15 and 15a
)
CANNOT
be used. Use the RHS101
within 36"
horizontal
or
60" vertical.
To install the RHS101, Slide the Inner Section over the vent pipe that will
connect to the fireplace. Fasten the vent pipe to the back of the fireplace
with a Min. of three sheet metal screws.
Next, slide the RHS101 outer section from the outside of the structure,
see
Figure 16
.
To complete the installation fasten the Heat Shield Outer Section &
Termination frame to the structure
Figure 16a.
RHS8 Heat Shield
1” Min. Both sides Typical
1” Min.
1” Min.
Combustible Framing
Figure 16b
.
RHS101 Installation.
Outer Shield 10 1/4”
3/8” Min. Both sides Typical
3/8” Min.
3/8” Min .
Combustible Framing
12” x 12”
Inner Shield 9 3/8”
Termination
Drywall / sheetrock
RHS101 Heat Shield, inner Section
RHS101 Heat Shield
Outer Section
Combustible
framing
Termination
Drywall / sheetrock
RHS101 Heat Shield, inner Section
RHS101 Heat Shield
Outer Section
Vent pipe, from fireplace
RHS8 Heat
Shield
36” Min
60” Min.
Termination
Note:
Images are shown without screens for clarity purposes. However,
your fireplace should not be operated without proper installation of
screens.
