H*42DF Indoor Gas Fireplace
Page 25
XG0148 - 151123
Installation
Section:
Section 8: Installing & Removing the Door
Removing the door:
The H*42DF* doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch
the door buckles and, remove the door. Replace in reverse order.
Figure 26a.
Locate the door buckles.
Figure 26.
Removing and installing the Horizontal Access Panel
Locate the Door Buckles:
Step 2:
Step 1:
Remove the Horizontal cover
by placing fingers in both
finger holes, then pushing
away from you and lifting
out. Place it aside during
maintenance or cleaning.
Install in reverse order.
Remove the Horizontal Access Panel:
2
Step 5:
Ensure the tool is firmly
in the lower end of the
slot, (as shown), Then pull
toward you (Caution: hold
the tool securely).
3
Step 6:
Pull hard if necessary to
release the spring ten-
sion. (Caution: The latch
springs back with force,
hold the tool securely).
4
Step 7:
Remove the tool from
the latch slot. Ensure
the latches are hanging
freely, the hook end is
released from the bottom
of the door. (Repeat all
4-steps for the remaining
latches).
Figure 26d.
Figure 26e.
Figure 26f.
Figure 21a.
Locate the door buckles. (Both Sides Typical)
Door Latch Hook
Door Latch Slot
Hand-hold
Release the Door Buckles
Figure 26b
. Door buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under
door frame. (as shown)
Figure 26c.
Step 3:
Finger Holes
Installed Gas
Valve Cover
WARNING
When reinstalling door(s), always make sure all door
buckles are properly hooked and fully engaged.
