Page 12
H52-DF Gas Fireplace
Part No. XG0650
Mantels & Surrounds
NOTE:
National Canadian Gas Association mantel test requirements
are for fire hazard prevention to combustible materials.
New technology, to meet consumer and government demands for the
wise use of energy, has prompted us to manufacture many models of
fireplaces which are hot, fuel and energy efficient.
Please be aware; temperatures over the mantel will rise above normal
room temperature and walls above fireplace may be hot to touch.
Figure 14.
Combustible surrounds.
Non-Combustible
Facing Material
Header
Drywall/
Sheetrock
6”
Installing the Log Set
Installing the Logs:
The
H52-DFN
is supplied with seven ceramic fibre logs. Unpack the logs
and handle them very carefully, install as described below.
Figure 16.
Installation of four (4) Base Logs.
Step 1.
Place the Base Logs, "
A
", "
B
", "
C
" & "
D
" as shown. Move them
left, or right to ensure they fit between the grate stiles as shown.
Figure 16a.
Installation of Log E.
Step 2.
Place flat portion (underside) of Log "
E
" on the formed steel
Log
Rest
as shown, lay front end of Log "
E
" approximately centre of
Log "
B
". See
Figure 16
above.
Figure 16b.
Installation of Log F.
Step 3.
Place Log "
F
" in place as shown. Rest front end of Log "
F
" in
curved area (notch) see
Figure 16a
on Log "
D
", and rear of Log
"
F
" on log Grate, between back stiles.
Installation
Log Grate
Log C
Log A
Log D
Log Rest E
Log B
Log E
Log Grate
Notch
Log D
Log B
Log Grate
Log F
plateau
plateau
