background image

Page 2

L-Series DF Gas Fireplace

Part No. XG0180

f i r e   f e a t u r e

Table Of  Contents

Introduction

Thank You for choosing a Montigo Gas Fireplace.

About this Fireplace:

The L-Series DF 

is a fireplace with a linear-style burner. This fireplace 

can be converted to both a Top Vent or Rear Vent application, and is 

only currently available in the L38-DF model.

The L38DF

 is rated for Natural Gas at 26,000 BTU/H (7.62 Kilowatts) 

Input or 

Propane at 26,000 BTU/H (7.62 Kilowatts) Input. 

L38DF;

 Top or Rear Vent, Millivolt Pilot.

L38DF-I; 

Top or Rear Vent, Intermittent Pilot (HSI).

L38DF-A;

 Top and Rear Vent, with Battery Back-up System

The L42DF

 is rated for Natural Gas and Propane at 32,000 BTU/H (9.97 

Kilowatts) Input. 

L42DF;

 Top or Rear Vent, Millivolt Pilot.

L42DF-I; 

Top or Rear Vent, Intermittent Pilot (HSI).

The L52DF

 is rated for Natural Gas at 40,000 BTU/H (11.73 Kilowatts) 

Input or 

Propane at 34,000 BTU/H (9.97 Kilowatts) Input. 

L52DF;

 Top or Rear Vent, Millivolt Pilot.

L52DF-I; 

Top or Rear Vent, Intermittent Pilot (HSI).

How to use this manual:

This manual covers installation, operation and maintenance. Lighting, 

operation and care of this fireplace can be easily performed by the 

homeowner.  However,  all  installation  and  service  work  should  be 

performed by a qualified or licensed installer, plumber, or gasfitter who 

is qualified or licensed by the state, province, region, or governing body 

in which the appliance is being installed.
This  manual  covers  all  models  and  unless  otherwise  specified,  the 

designation  L-Series  DF

  refers  to  all  models.  Sections  which  are 

specific to a particular model are marked with a 

 symbol, plus 

the appropriate model number.

Warranty and Installation Information:

The Montigo warranty will be voided by, and Montigo

 

disclaims any 

responsibility for, the following actions:

Modification  of  the  fireplace  and/or  components  including  Direct-Vent 

assembly or glass doors.
Use of any component part not manufactured or approved by Montigo in 

combination with this Montigo fireplace system.

Installation other than as instructed in this manual.

Consult your local Gas Inspection Branch on installation requirements 

for factory-built gas fireplaces. Installation & repairs should be done by 

a qualified contractor.

Installations in Canada

 must conform to the current 

CAN/CGA B-

149.1 and .2 Gas Installation Code and local regulations. If the optional 

air-circulating  fan  kit  is  installed,  it  must  be  electrically  grounded  in 

accordance with 

CSA C22.1

 Canadian Electrical Code Part 1 and/or 

Local Codes.

Installations in the USA

 must conform to local codes, or in the absence 

of local codes to the National Fuel Gas Code, 

ANSI Z223.1-1988. If the 

optional air-circulating fan is installed, it must be grounded in accordance 

with local codes or, in the absence of local codes, with the National 

Electrical Code, 

ANSI/NFPA 70-1987. Within the

 State of Massachusetts 

this fireplace must comply with 

NFPA-54 Chapter 10

.

Introduction  .............................................................................. 2
Installation

 

Installing and Framing the Fireplace

 ..............................

3

 

Installing the Gasline ...................................................... 4

 

Vent Installation

 .............................................................. 4

 

 

Installation Requirements

 .................................. 4

                         Installing the Remote Switch

 ............................. 5 

 

 

Vent Terminations

 .............................................. 5

                         Converting  to Top Vent / Rear Vent

 .................. 6

 

 

Top Vent Venting Runs 

 .....................................

7

 

 

Rear Vent Venting Runs

 .............................

11-12

 

 

Venting for Rear Vent models

 ..........................

13

 

Finishing around the fireplace

 

 

Fireplace Facing ..............................................

14

 

 

Mantels and Surrounds

 ...................................

14

 

 

Surround Heat Shield

 ......................................

14

 

Wiring   .........................................................................

15

 

            Wiring for the Optional Fan Kit

 .........................

15

 

Removing and Installing the Door

 ................................

15

Operation  .........................................................................

16 - 19

Maintenance  ...........................................................................

20

            Troubleshooting

 ............................................................

20

Warranty  .................................................................................

21

Appendix

 

A. Termination Locations

 .............................................. 22

 

B. Spare Parts List

 .......................................................

23

CAUTIONS

Due to its high operating temperatures, the appliance 

should  be located out of traffic & away from furniture 

and draperies.

Children and adults should be alerted to the hazards 

of the high surface temperature, which could cause 

burns or clothing ignition.
Young children should be carefully supervised when 

they are in the same room as the appliance.
Clothing or other flammable materials should not 

be placed on or near the appliance.

Summary of Contents for L38DF series

























Reviews: