Page 23
L52DF* Indoor Gas Fireplace
XG0185 - 100511.1
Installation
Section 7: Installing & Removing the Door
Removing the door:
The
L52DF*
doors are removed in a few simple steps. Follow these
instructions below to remove the Horizontal access panel, unlatch the
door buckles and, remove the door. Replace in reverse order.
Figure 24a.
Locate the door buckles.
Figure 24.
Removing and installing the Horizontal Access Panel
Locate the Door Buckles.
Step 2:
Step 1:
Remove the Horizontal cover
by placing fingers in both finger
holes, then pushing away from
you and lifting out. Place it aside
during maintenance or cleaning.
Install in reverse order.
Remove the Horizontal Access Panel:
To install the door, hook the top edge of the door frame into place. Lower
the door into position and follow the previous steps shown in reverse order.
Installing the Door:
2
Step 5:
Ensure the tool is firmly in
the lower end of the slot,
(as shown), Then pull toward
you (Caution: hold the tool
securely).
3
Step 6:
Pull hard if necessary to
release the spring tension.
(Caution: The latch springs
back with force, hold the tool
securely).
4
Step 7:
Remove the tool from the
latch slot. Ensure the latches
are hanging freely, the hook
end is released from the
bottom of the door. (Repeat
all 4-steps for the remaining
latches).
Figure 24d.
Figure 24e.
Figure 24f.
Step 8:
Grasp the Door on either side, usually midway and lift upward, lift
the door carefully up and away from the front of the fireplace.
See
Figures 24g
. Place the Door aside in a safe place while maintenance
and / or cleaning is being performed.
Figure 24g.
Removing and installing the glass doors.
Removing the Door:
Door Latch Hook
Door Latch Slot
Hand-hold
Figure 24b
. Door buckle Tool
1
Step 4:
Firmly grasp hand-hold
end of Door buckle tool
and place the machined
end in the slot under door
frame. (as shown)
Figure 24c.
Finger Holes
Installed Gas
Valve Cover
Step 3:
Locate Door Buckle Tool.
