Page 9
XG0128
M38ODV-ST Direct Vented Fireplace
Removing and Installing the
Door
Removing the door surround:
The door surround is held in place by two metal clips at the top, and
one magnet on each side. To remove the surround, pull the bottom
outwards and lift upwards until the slots "A" are clear of tabs "B" in the
door. You may need to use a flat screwdriver to pull the door surround
outwards.
(See figure 13).
Figure 13.
Removing door surround.
Removing the door:
To install/remove the glass door simply attach/remove the four (4)
machine screws, align tabs at the bottom of the door with the slots in
the bottom door rail
(See figure 14).
Ensure that a good seal is
maintained.
Figure 14.
Installing Glass Door.
Glass door
and frame
Door surround
Tab 'B'
Slot 'A'
Magnet
Pull bottom of
door surround
outwards and
upwards.
Machine Screws
Door Rail
Tabs
Installation
Figure 12b.
Completed Installation.
Figure 12a.
Log Installation.
Installing the Logs and Embers
Bottom Logs
The
M38ODV-ST
is supplied with five (5) fibre logs. The two large
bottom logs (logs
"A"
and
"B")
are mounted on the burner grate by
placing them into the slots.
Top Logs
Place logs
"C"
and
"D"
into their mating positions on the large logs as
shown in Figure 12a below
.
Log
"E"
is mounted on top of logs
"C"
and
"D"
as shown in Figure 12b.
WARNING:
WARNING:
WARNING:
WARNING:
WARNING: If logs are not placed properly, excessive
sooting will result.
