Page 11
XG0204 04/05
Panorama Direct Vented Fireplace
For Your Safety - READ BEFORE LIGHTING:
WARNING:
If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
Department.
C.
Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified serv
-
ice technician. Force or attempt to repair may result in
a fire or explosion.
D.
Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system, and any gas control which has been
under water.
A.
This appliance has a pilot which must be lighted by
hand. When lighting the pilot, follow these instructions
exactly.
B. BEFORE LIGHTING
smell all around the appliance
area for gas. Be sure to smell next to the floor be
-
cause some gas is heavier than air and will settle on
the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any
phone in your building.
Immediately call your gas supplier from a neigh-
bour's phone. Follow the gas supplier's instruc-
tions.
If you cannot reach your gas supplier, call the Fire
To Turn Off Gas To Appliance:
Operation - Model M38DV-PRC
3. Push in gas control knob slightly and turn
clock-
wise to "Off". Do not force.
4. Replace lower trim.
1. Turn off remote switch.
2. Remove lower trim.
1.
STOP!
Read the safety information above on this
label.
2.
Remove lower trims.
3.
Push in gas control knob and turn clockwise
to
"OFF."
4.
Wait five (5) minutes to clear out any gas. Smell for
gas, including near the floor. If you then smell gas,
STOP!
Follow "B" in the safety information above on
this label. If you don't smell gas, go to the next step.
5.
Locate pilot burner
(See illustration at right.)
and fol-
low steps below.
6.
Turn knob on gas control counterclockwise
to
"PILOT."
7.
Push in gas control knob completely and hold. Light
with Piezo Igniter button. Continue to hold the control
knob in for about (1) minute after the pilot is lit. Re
-
lease the knob and it will pop back up. Pilot should
remain lit. If it goes out repeat steps 3 through 8.
If knob does not pop up when released. Stop and
immediately call your service technician or gas
supplier.
If the pilot will not stay lit after several tries, turn
the gas control knob to "OFF" and call your service
technician or gas supplier.
8.
Push in gas control knob and turn counterclockwise
to "ON."
9.
Replace lower trim.
10.
Turn on remote switch to ignite fire.
Lighting Instructions:
with Continuous Pilot
M38DV-PRC
NOTE:
Knob cannot be turned from
"PILOT" to "OFF" unless knob is
pushed in slightly. Do not force.
Gas Control Knob
(Shown in "Pilot" postion.)
