Page 4
Proflame 2 Transmitter
XG0677 - 141231
Operation
Figure 3.
Remote Control LCD display.
Initializing the System for the first time
1. Install four (4) AA batteries into the battery holder
located under the firebox. (Not applicable for Power
Vented Units)
2. Install three (3) AAA batteries in the back of the remote
control, see
figure 4a
.
Note the polarity of batteries and install them as indicated
by the silk screen (+/-) on the holder.
3. Set manual switch to OFF position, see
figure 6
.
4. Connect AC Power (120 volts, 60 Hz) to fireplace.
Operating the System for the first time
5. Press SW1 button on the control module. The control
module will beep three (3) times and amber LED, see
figure 2,
is illuminated to indicate that the IFC is ready
to synchronize with a remote control within 10 sec. Push
the ON button. The control module will "beep" four (4)
times to indicate transmitter's command is accepted.
The System is now initialized.
Figure 4a.
Remote control battery compartment.
Battery operated device.
Read the battery instructions before installing them
.
WARNING
into the system. Do not expose any battery, or its holder, or a device in which
batteries are installed, to a working temperature greater than 54°C / 129°F.
Avoid battery overheating even if the working temperature of the device to which
the batteries are connected is reported to be greater than 54°C / 129°F. In case
of overheating the bad cases, develop hydrogen gas and explode.
Figure 4.
Control Module Battery Pack
(Not applicable for Power Vented Units)
