R324-STIO Indoor Outdoor Ventless Gas Fireplace
Page 13
XG0775 - 150204.1
Installation
Section 6-b: Removing & Installing the Outside Screen and Door
Step3.
To remove the outer door, remove screws that secure the door to the
fireplace. Make sure to hold onto the door securely as you remove the last few screws.
Step4.
To reinstall, reverse steps
.
Do not use ammonia based or abrasive cleaners on the glass, they will permanently
etch the surface. Use an approved gas fireplace glass cleaner such as Kel-Kem or
White off.
NOTICE
Step1.
Lift the decorative screen frame up and out, and off of the fireplace (as
shown below in Figure 7e).
Figure 7e. Lifting screen frame up and out.
Figure 7f. Lifting screen frame off fireplace.
Step3.
Remove the screws that secure the screen to the unit. Make sure to hold the
screen securley as you remove the last few screws to prevent the screen from falling.
Figure 7g. Removing screws that secure screen.
Figure 7h. Removing screws that secure door.
REVISIONS
REV.
DESCRIPTION
DATE
CHANGED BY
-
.
-
-
1:16
DWG. NO.
SHEET 1 OF 1
WEIGHT:
R324-MAN1
Finish
MATERIAL
DIMENSIONS ARE IN INCHES
TOLERANCES:
FRACTIONAL 1/32"
TWO PLACE DECIMAL .015"
THREE PLACE DECIMAL .005"
ALL BENDS ARE ASSUMED
TO BE 90 UNLESS NOTED
OTHERWISE.
Revision / Date
Drawn by
DATE
NAME
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF CANADIAN HEATING PRODUCTS. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF CANADIAN HEATING PRODUCTS IS PROHIBITED.
PROPRIETARY AND CONFIDENTIAL
Y:\CADD\2007 CADD\Custom\ST Indoor-Outdoor\ST Fireplace
March-11-15 11:06:43 AM
SCALE
PC
Description
MANUAL IMAGE 1
A
Revision
03/11/2015
Figure 7i Screen removal (3D rendering)
