Installation
Page 3
XG0675 - 151207
WARNING
This remote control system must be installed exactly as outlined in these instructions. Read all instructions
completely before attempting installation. Follow instructions carefully during installation. Any modifications of this
remote control or any of its components will void the warranty and may pose a fire hazard.
Wiring Instructions
A qualified electrician should install the remote control
system
1.
Disconnect and remove the wall switch wire from
terminals 3 and 4 of the control box. See
Figure 3
or
Figure 3a
.
2.
Feed the red wires from the remote receiver through
the control box side. See
Figure 5
.
3. Connect the Red wires to Terminals 3 and 4 of the
control box. See
Figure 3
or
Figure 3a
. When con
-
necting two connectors together on a single pole,
place connectors back-to-back. See
Figure 4
.
4. Plug the power cord from the receiver into the 110VA
plug on the side of the control box. See
Figure 5
.
5.
Attach the receiver to the control box cover or to the
wall using the velcro strips attached. See
Figure 6
.
3 4
Connection
110 VAC
Red Wires
From Receiver
3 4
Figure 3.
Connection to Control Box
Figure 3a.
Connection to Control Box
(RP424PFC)
Figure 5.
Plug to receptacle
Figure 6.
Installing Receiver
Figure 4.
Place connectors back-to-back when installing
