ENGLISH
19
8.1
8.2
1
2
3
1
2
3
4
5
6
7
CORRECT USE - SQUARE AND RECTANGULAR HOLES
CORRECT USE - 45°
• Position the tile against the square.
• Press down to switch the driving handle and lock it.
• The correct position of the hands is shown in figure 7.
• Proceed to cutting by slowly positioning the diamond disk against the material to be cut, advancing
with a speed proportional to the thickness and hardness of the material.
• Slow down the advancement speed near the end of cutting.
• After having completed the cut, turn off the engine through the switch. Bring the engine back to its
original position.
• Whenever the end of the tile breaks (the last centimeter), sharpen the diamond disk. If the defect
remains it can remedied in the following way:
1 - make a cut of about 2 cm from one side of the tile.
2 - rotate it and follow the cut through until reunification with the 2 cm cut previously carried out.
• Maximum material thickness
3.5 cm.
• Gradually press down on the
driving handle so that the disk
enters the plate and emerges
from the opposite side.
• The correct position of the
hands is shown in figure 3.
45°
