montpellier GH60BG, Installation And Operating Instructions Manual

5

S

ection 1. Installation 

-

Remove all packaging, protective film and securing tape from

the appliance.

-

Position the appliance in a dry atmosphere.

-

The following dimensions are provided as a guide for

installation – your 

GasSafe

 installer will carry out the installation

in accordance with the current regulations.

-

Your 

GasSafe

 installer will connect the appliance in accordance

with the current regulations.
To install this appliance, please proceed as follows:
1.1.  Work-Surface Cut-Out & Positioning

-

Cut out the work-top, ensuring that the actual sizes used are as

per the diagram below (553mm x 473mm).

-

For installation and use, a minimum of 5cm must be maintained

around the cut-out.

-

The work surface must have a thickness of at least 30mm.

-

The work surface must be heat resistant.

-

The rear edge of the hob must be at least 60mm from the rear

wall.

-

You must maintain a clearance of at least 700mm between the

top of the hob and any surface directly above it.

-

Note the clearances required between the hob/work surface

and any adjacent wall cupboard (400mm).

-

You must ensure that there is a minimum gap of 25mm

between the bottom surface of the hob and anything

positioned directly below it.