montpellier MON-M604DDAP, Installation And Operating Instructions Manual

7 

 
 
Section 2. Safety Advice 



  Please read this booklet thoroughly before installing and switching on the 

appliance.  The manufacturer accepts no responsibility for incorrect installation 
and usage. 



  If this appliance is to replace an old refrigerator with a lock, as a safety measure 

break or 

remove the lock and/or door

 before disposal. 



  Your old appliances contain insulation gases and refrigerant that must be 

disposed of correctly.  Please ensure that the refrigerant circuit is not damaged 
before the appliance is taken away for correct disposal in line with current 
legislation.  If there is any doubt contact your Local Authority for instructions. 



  This appliance may contain the refrigerant isobutene (R600a).  This is a natural gas 

with a high level of environmental compatibility; however, caution is required as 
isobutene is a flammable gas.  It is essential to ensure that refrigerant tubes are not 
damaged during transportation and the installation of the appliance.  In the event 
that the refrigerant circuit is damaged, avoid naked flames or sources of ignition and 
ventilate the room in which the appliance is situated. 



  Do not damage the refrigerant circuit. 



  The appliance is not intended for use by persons (including children) with 

reduced physical, sensory or mental capabilities, or lack of experience and 
knowledge, unless they have been given supervision or instruction concerning 
the use of the appliance by a person responsible for their safety. Children should 
be supervised to ensure that they do not play with the appliance. 



  If using an adaptor, this must be used in accordance with the manufacturers 

instructions and ensure that the electrical circuit is not overloaded as this could 
cause overheating. 



  Do not twist or bend the cables, and keep them away from hot surfaces. 



  Do not plug ın or unplug this appliance with wet hands. 



  Following installation make sure that the power cable is not trapped underneath 

the appliance.



  Ensure the appliance is left in an upright position for at least 4 hours before you 

switch it on. 



  The plug supplied with this appliance must be fitted with a 13 Amp fuse.



  If the power supply cord is damaged, it must be replaced by the manufacturer, 

it’s service agent or similarly qualified persons in order to avoid a hazard.