~
Before connecting the appliance to the mains electricity supply make sure that the
connection data on the data plate (voltage and frequency) correspond with the mains
electricity supply, otherwise the appliance could be damaged. Consult a qualified
~
The socket and on-off switch should be easily accessible after the appliance has been
built in.
~
The warming drawer may only be built in combination with those appliances
quoted by the manufacturer as being suitable. The manuafacturer cannot guarantee
~
When building in the warming drawer in combination with another suitable
appliance, the food warming drawer must be fitted above a fixed interim shelf in the
housing unit. Please ensure that the housing unit can support both its weight and that
of the other appliance.
~
As the combination appliance is placed directly on top of the warming drawer
once it is built in, an interim shelf is not necessary between the two appliances.
~
The appliance must be built in so that the contents of the drawer can be seen.
This is to avoid scalding from hot food spilling over. There must be enough space
~
The warming drawer is available in two models, which differ in opening the door.
dimensions for the combination appliance to establish the
niche size
required.
When building in the combination appliance, it is essential
to follow the instructions given in the operating and
installation instructions supplied with the combination
appliance.
All dimensions in this instruction booklet are given in mm.
Safety instruction for installation
electrician if in any doubt.
trouble-free operation if the appliance is operated in combination with appliances
other than thouse quoted by the manufacturer as being suitable.
for the drawer to be pulled out fully.
in
The building-in dimensions for the warming drawer must be added to the building-
22
