montpellier WS19SDX, Installation And Operating Manual

4

Section 1: Safety Advice

• Please read this booklet thoroughly before

installing and switching on the appliance.

The manufacturer accepts no responsibility

for incorrect installation and usage.

• If this appliance is to replace an old

refrigerator with a lock; as a safety

measure break or remove the lock and/or

door before disposal.

• Your old appliances contain insulation

gases and refrigerant that must be

disposed of correctly.  Please ensure that

the refrigerant circuit is not damaged before

the appliance is taken away for correct

disposal in line with current legislation.

If there is any doubt contact your Local

Authority for instructions.

• This appliance may contain the refrigerant

isobutene (R600a).  This is a natural gas with

a high level of environmental compatibility;

however, caution is required as isobutene

is a flammable gas.  It is essential to ensure

that refrigerant tubes are not damaged

during transportation and the installation

of the appliance.  In the event that the

refrigerant circuit is damaged, avoid naked

flames or sources of ignition and ventilate

the room in which the appliance is situated.

• Do not damage the refrigerant circuit.

• The appliance shall not be used by children

aged from 8 years and above and persons

with reduced physical, sensory or

mental capabilities, or lack of experience

and knowledge, unless they have been

given supervision or instruction on how to

use the appliance in a safe way and

understand the hazards involved. Children

shall not play with the appliance. Cleaning

and user maintenance shall not be made

by children without supervision.

• Do not allow children to play with the

appliance.  Children must never play in

or around the appliance.

• If using an adaptor, this must be used in

accordance with the manufacturer’s

instructions and ensure that the electrical

circuit is not overloaded as this could

cause overheating.

• Do not twist or bend the cables, and keep

them away from hot surfaces.

• Do not plug ın or unplug this appliance with

wet hands.

• Following installation make sure that the

power cable is not trapped underneath

the appliance.

• If the power supply cord is damaged, it

must be replaced by the manufacturer, it’s

service agent or similarly qualified persons

in order to avoid a hazard.