Approved use
The LED house number light with a twilight sensor
areas, and has an independent solar panel and
solar module on top of the house number charges
no more power. This light must be installed
outdoors in full sun and away from any shade or
shadows.
CAUTION!
There is a risk caused by vapours or electrolyte
is a risk of injury if you come into contact with
these. This could lead to serious injuries, such as
loss of vision or burns.
LED light beams also pose a danger!
Looking into an illuminated LED can lead to
- Do not install your house number light in poten-
- Protect the solar panel from mechanical loads.
Note:
where it is located.
In winter, ensure the solar panel is kept free of
snow.
a risk that children might swallow them.
be short-circuited, disassembled or thrown onto
-
kit and secure the hanging plate as shown.
If the lamp is not working properly or only lights
arrow.
Drill 2 x 6 mm holes in the wall. The distance
between the centre of each should be 10.9cm.
Press plugs into the holes and screw in 4x2
self-tapping screws. Please remember that the
screws must protrude by 4-6mm so the light can
INSTRUCTIONS
ATTENTION!
Observe the safety and assembly
damaging the product.
use!
through at a later date. If you give the product to
anyone else at some point in the future, please
ensure you also pass on this manual.
Keep small parts out of the reach of children. Pay
Check all elements and parts for damages.
Despite careful checks since may happen that
even the best product takes damage during the
transport.
In this case, do not build up of your product.
Never modify the product! Changes will void the
warranty and the product may be unsafe or even
dangerous.
For cleaning use a sponge and warm soapy water.
Do not use solvent based-cleaners or detergents
for example Bleach those can damage the
product.
4
5
www.DeubaXXL.de
www.DeubaXXL.de
135mm
/13.5cm
be attached
