Improper transport
NOTICE!
Damage to property due to improper
transport!
Transport units may fall or tip over as a
result of improper transport. This can
cause a significant level of property
damage.
– Proceed carefully when unloading
transport units at delivery and during
in-house transport; observe the sym-
bols and instructions on the packaging.
– Only use the attachment points pro-
vided.
– Only remove the packaging shortly
before assembly.
5.2 Inspection on receipt of delivery
On receipt, immediately inspect the delivery for
completeness and transport damage.
Proceed as follows in the event of externally appa-
rent transport damage:
n
Do not accept the delivery, or only accept it
subject to reservation.
n
Note the extent of the damage on the transport
documentation or the shipper's delivery note.
n
Initiate complaint procedures.
Issue a complaint in respect of each defect
immediately following detection. Damage
compensation claims can only be asserted
within the applicable complaint deadlines.
5.3 Packaging
About packaging
The individual packages are packaged in accord-
ance with anticipated transport conditions. Only
environmentally-friendly materials have been used
in the packaging.
The packaging is intended to protect the individual
components from transport damage, corrosion and
other damage prior to assembly. Therefore do not
destroy the packaging and only remove it shortly
before assembly.
Handling of packaging materials
Either keep packaging material for a later dispatch
or storage the device or dispose of it in accord-
ance with the valid local regulations legal provi-
sions and local regulations.
NOTICE!
Risk of environmental damage from
incorrect disposal!
Packaging materials are valuable raw
materials and can in many cases be used
again or prepared sensibly and recycled.
Incorrect disposal of packaging materials
can cause environmental hazards.
– Dispose of packaging materials in an
environmentally-friendly fashion.
– Heed the local disposal regulations.
Have disposal carried out by a spe-
cialist company as necessary.
5.4 Symbols on the packaging
The following symbols may be affixed to the pack-
aging. Always adhere to the symbols during trans-
portation.
Attach here
Only use means of attachment (chain sling, lifting
strap) in the places marked with this symbol.
Rotopack • Operating instructions
16
