Page 44
Voyager User’s Manual - PANEL Mode
Page 45
Voyager User’s Manual - PANEL Mode
MASTER/HP VOLUME (RME only):
MASTER/HP VOLUME is used to determine whether the stored Master
Volume and Headphone Volume values are loaded when a new preset is
selected. If this is off, then these values are determined by the current po-
sition of these controls. To make a change in the Master/HP Volume menu,
use the
CURSOR
to highlight the desired choice and press
ENTER
.
T.S. REDUCTION:
T.S. REDUCTION (Touch Surface Reduction) thins the number of MIDI
CCs sent by the Touch Surface Inputs when more than one is used at a
time. The amount of MIDI data produced by the Touch Surface can be
immense, and can crash some MIDI devices. To make a change in the T.S.
Reduction menu, use the
CURSOR
to highlight the desired choice and
press
ENTER
.
REAL PANEL PARAM.:
REAL PANEL PARAM (Real Panel Parameters) is a function that enables
the operation of the Voyager from the actual settings of front panel
controls, rather than preset memory. If you select ‘YES’ the sound
produced when the Voyager is played will be determined by the settings
of the front panel controls. To make a change in this menu, use the
CURSOR
to highlight the desired choice and press
ENTER
.
GLIDE FUNCTION (RME only):
This function works like the
GLIDE
switch on the left-hand control panel
of the Voyager keyboard – it switches the Glide function ON or OFF. To
make a change in this menu, use the
CURSOR
to highlight the desired
choice and press
ENTER
. The change will take effect for the current
preset Like all changes, if you wish to keep the change you must save the
preset. For more information, see ‘SAVE PRESET’ in the Edit Mode section.
For the RME, the Touch Surface Inputs are on the optional VX-352 CV Expander. With
the VX-352 connected, you can route any 0 to +5V control input connected to the Touch
Surface inputs to any Touch Surface Destination through the RME’s software and save in
a preset.
HEADPHONE VOLUME (Keyboard Editions only):
HEADPHONE VOLUME is used to determine whether the stored Head-
phone Volume value is loaded when a new preset becomes active. If this
is off, then this value is determined by the current position of the
HEAD-
PHONE VOLUME
control. To make a change in the Headphone Volume
menu, use the
CURSOR
to highlight the desired choice and press
ENTER
.
