Page 50
Voyager User’s Manual - EDIT Mode
Page 51
Voyager User’s Manual - EDIT Mode
1.4 PITCH BEND AMT. (PITCH BEND AMOUNT):
The PITCH BEND AMT function allows you to set separate up and down
pitch bend ranges for each preset. To adjust the ranges, use the
CURSOR
to toggle between the Pitch Bend UP and Pitch Bend DOWN parameters,
and use the
-1/+1
buttons to select the desired range.
The selection ranges for the UP and DOWN parameters are:
Off
+/- Fourth (default)
+/- 2 Octaves
+/- 2 Semitones
+/- Fifth
+/- 2 Octaves & 5
th
+/- Minor Third
+/- 1 Octave
Pre. –Value
+/- Major Third
+/- 1 Octave & 5
th
‘Pre. –Value’ is a user defined amount. The value of this is set with
the EXTERNAL level control on the Mixer. To set the value, simply
push the Pitch Bend Wheel forward and listen to the pitch change as
you rotate the EXTERNAL control, stopping when the desired interval
is reached.
2.1 PGM M-WHL SOURCE (Programmable Modulation Wheel Source)
PGM M-WHL SOURCE that allows you to program one of 8 additional
modulation sources to be used when the Mod Wheel Bus
SOURCE
control is set to ‘NOISE/PGM’. To select a source, use the
-1/+1
buttons
to highlight the desired selection and press
ENTER
.
The available sources are:
Noise (default)
Oscillator 1
Filter ENV
Oscillator 2
Amplitude ENV
Touch Surface X
Smoothed Sample and Hold
Touch Surface Y
2.2 PGM M-WHL DEST. (Programmable Modulation Wheel Destination):
PGM M-WHL DEST allows you to program one of 8 additional
modulation destinations to be used when the Mod Wheel Mod Bus
DESTINATION
control for the set to ‘LFO RATE/PGM’. To select a
destination, use the
-1/+1
buttons to highlight the desired selection and
press
ENTER
.
The available destinations are:
LFO Rate (default)
Osc. 1 Level
Filter Resonance
Osc. 2 Level
Filter Spacing
Osc. 3 Level
Panorama
Noise Level
