Practical recommendations
31
1
Before all maintenance, service or repairs and when trying to identify a breakdown or
malfunction you must ensure that the power drive is disconnected and that the engine is
switched off and the ignition key removed.
2.
Check Tightness of screws and nuts. Retighten if necessary. (Especially Transport
Wheels).
3.
Before maintaining a machine in the raised position, support it by appropriate means.
4.
Before replacing a working part, wear protective gloves and only use the appropriate
tools.
5.
To protect the environment, it is forbidden to throw or pour out oils, grease and filters of any
description. They should be given to firms specialising in their disposal.
6.
Before undertaking any electrical work on the tractor or attached machine disconnect the
alternator cable and the battery.
.
7.
Protective covers which are prone to wear should be checked regularly. Replace immediately
if
damaged.
8.
Spare parts must conform to the manufactures specification. Only use genuine Moore parts.
9.
Before working on any electrical circuit disconnect the power source.
10.
Repairs carried out on parts under tension or pressure (springs or components under
pressure etc) require specialist knowledge and tooling so should only be carried out by
qualified
personnel.
11.
In the winter time leave the base flap fully open so any rodents can escape otherwise they will
chew through a peg wheel to get out.
12.
Do not leave any seed in the machine after the drilling season is finished
13.
If it is noticed that during drilling, the coulters behind the tractor wheels are not drilling at the
same depth as the rest, the dragarms on these coulters can be preloaded by placing washers
or similar spacers between the front spring - lower and the spring locating bush
.
Summary of Contents for 240G
