MOOSE J50FL, User Manual

10

DISSASSEMBLY

To dismantle the scooter just reverse the steps for assembly.

*You must power off your scooter before dissassembly.

(1) Turn off the power and take out the power key from switch lock.

(2) Loosen and Remove the seat from the seat post.

(3) Disconnect the turning lights cable and remove the rear fairing.

(4) Disconnect the main battery cable from the controller.

(5) Unplug all battery connections.

(6) Remove the batteries from floor pan.

(7) Disconnect the front chassis cable from the controller.

(8) Fold down the tiller to horizontal.

(9) Pull out the security pins from the positioning holes.

(10) Holding the tiller by one hand and seat post by another, push away 

from each other, while swinging both modules slightly up and down.

TRANSPORTATION

Of course, the best way to transport your scooter is when it’s fully assem-

bled to avoid possible mistakes during its installation. The Journey  

Series scooters can fit most car models. Following the steps below will aid 

in the transportation of your scooter.

(1) Place the rear chassis first into the car trunk. Put it close to one side 

and ensure that the clutch is engaged for avoiding possible movement 

during the trip.

(2) Place the front chassis across the remaining section of the trunk.

(3) Load the batteries.

(4) Place the seat in a way that the upholstery is protected. In case there is 

no room for the seat, place it upside down on the back seat of your car.