MOOSE V80FL-S, User Manual

9

ASSEMBLY AND DISSASSEMBLY

The scooter has been designed to assembled and disassembled quick-

ly and easily without the use of tools. Excessive force should not be 

required. If you encounter a problem, please refer to the User’s Guide, 

then try again. If the problem persists, don’t hesitate to call your autho-

rized dealer for assistance.

PIECES

The scooter consists of the following main modules, which you can put 

together or dismantle without using any tools:

(1) Front chassis   (2) Rear chassis   (3) Seat    (4) Two batteries

(5) Rear fairing

ASSEMBLY

(1) Clean the two joint heads on the rear chassis.

(2) Position the front and rear chassis such that the joint heads and 

holes are aligned.

(3) Taking the wheels as swinging pivots lift the front and rear chassis 

slightly till the heads and holes are at the same level.

(4) Pull the two chassis together.

(5) Insert the security pins into the positioning holes.

(6) Plug the control cable from the front chassis into the receptacle 

on the rear chassis.

(7) Adjust the tiller angle by loosening and tightening the knobs at the 

lower and upper joints.

(8) Place batteries onto the floor pan and secure them.

(9) Join each battery with the branched cable first, and then join it with 

the receptacle from the controller box.

(10) Join all cables with the same labeling, except the cable for turning 

lights.

(11) Put the rear fairing in place and connect the cable for the turning 

lights.

(12) Set the seat on the  seat post and lock the seat in position by tighten-

ing the knob.

(13) Adjust the height of the seat by bolt on the seat post under the seat.