7
Security Module Connections
L. Connect the 24-way connector into
the PC-12 Security module.
Mount module
M. Using supplied wire ties, secure the
module to existing wire harnesses
and/or braces under the dash.
Status LED
J. Drill 9/32” hole in trim panel as shown
in diagram. Exact placement needs to
be determined before drilling. Ensure
there is nothing on the backside of the
panel and there is enough depth for the
LED when the panel is replaced. Once
drilled, feed the female connector and
LED through the opening and snap into
place. Route 2-pin harness from main
wire harness to LED mounting location
and mate connectors.
Horn Connection
K. Locate the Dk Green/Violet wire in pin
#2 of the 6-way white connector found
underneath the steering column.
Center-splice the harness Dk Green
wire into this wire, following the center-
splice procedure.
7AY
