2
TOOLS REQUIRED
Long Phillips Head Screwdriver
Short Phillips Head Screwdriver
8mm, 9mm ,10mm ,13mm Sockets
T15, T27 Torx Head Sockets
Ratchet w/ Short/ Long Swivel Extensions
Sidecutters
CAUTION:
XBM remote start can ONLY be installed on vehicles that have the following factory options: Automatic Trans
mission, Remote Keyless Entry and Immobilizer.
WinFobik based vehicles, the sales code must be added to the database and the Restore Vehicle Configuration
(using a diagnostic scan tool) must be performed prior to installing the new WIN module. Failure to do so will
render the WIN module’s remote start function inoperative.
The technician should wait 1/2 hour between adding XBM sales code in DealerConnect before installing the WIN
module & restoring vehicle configuration. In the interim, the technician can install all other components except
the WIN module.
NOTE: It is recommended to read the instructions thoroughly before installing this product.
PROCEDURE STEPS:
UPDATE VEHICLE CONFIGURATION
NOTE: The wiTECH software level must be at the latest release to perform this procedure.
1.
VIN must be updated with the sales code of the added accessory in order to enable system functionality. Using the
DealerCONNECT website and the wiTECH diagnostic application, complete the vehicle configuration.
2.
Log on to https://dealerconnect.chrysler.com.
3.
In the "Vehicle Option" screen under the "Global Claims System" category in the "Service" tab, enter the vehicle
VIN, four digit pin number obtained from the dealership parts department and add sales code(s) noted below as a
"Dealer Installed Option".
XBM (REMOTE START)
4.
Confirm that the new sales code has been successfully added to the VIN.
5.
With the wiTECH diagnostic application, perform the following steps form the Initial Start Up Screen:
• Select the "DIAGNOSTIC PROCEDURES" tab
• Select "RESTORE VEHICLE CONFIGURATION"
• Select the "Run Diagnostic" button
• Select "CONTINUE"
• Verify that the vehicle VIN number is correct
• Once verified, select the "Correct VIN" button
• Note OnScreen instructions and select the "Close" button
PROCEDURE STEPS:
Jul 01, 2011
K6861201
4280416
