ENOWd – Gateway EnOcean ®
Hardware: V1.31
Firmware: V1.3
6.
ADDRESSING AND CONFIGURATION:
Before you can address the ENOWd you will have to enter the
license card supplied with the module into the Mordomus
software.
The ENOWd is ready to be addressed when Led D2 is on.
To assign the desired address to the module proceed as
following:
1.
Open the "Registering Modules" window at
Mordomus software.
2.
Remove the module cover loosening the housing
screws by means of a PH1 tool.
3.
Press (Addressing) button inside the module. The
4.
D2 Green LED will flash slowly and the D4 Red LED
will pulse once. Note that after three minutes without
having assigned a new address, the module
automatically returns to normal mode.
5.
Define the desired address at Mordomus software at
the displayed window.
Repeater:
When active, all EnOcean telegrams that have not
yet been repeated by another repeater, will be forwarded by
ENOWd. (Level Repeater 1).
To enable or disable the repeater, press and hold the button
Addressing
for more than 3 seconds. When LED
D5
is lit the
repeater is enabled, and when
D5
is off the repeater is also
off. This configuration is automatically stored in non volatile
memory.
7.
FUNCTIONING:
Code of Leds:
D2
Green LED:
Access - Module powered and registered;
Briefly pulse - Module receiving data by Bus Mordomus;
Intermittent - Module waiting address.
D4
Red LED:
Brief pulse - Module receiving data by Bus Mordomus.
Pulse 10 in 10 seconds - Module waiting registration.
D3
Green LED:
Briefly pulse - Module to receive wireless data;
D5
Red LED:
Briefly pulse - Module to send wireless data.
Reset:
To perform a reset to the module, cut power supply
12VDC for a few seconds or place the jumper according to
Fig 2 b) for about 3 seconds and put it back in its original
position Fig 2 a).
Manual: ENO-1642-EN
Page
2
/
2
