ENGLISH
17
4.
Seat
Before sitting , place the rollator on a flat and solid surface and then lock the brakes.
Make sure the latch of the lock is secured properly and that the rollator is in a stable position.
WARNING!
Questions to sit down with your weight on the seat assembly.
Do not sit by pushing only on oneside.
5.
Footrest
Insert the footrest into
the
pin’s frame. If you
don’t need fix they on
the frame using the clip,
like in the picture.
7.3 Assembling model RP545
-
Turn the wheel in the correct direction, unbuckle the belt which locks the rear wheels
and lock the rear wheels and front with knobs supplied.
-
The first time that the rollator will be mounted handles with the knobs will not be
connected, and then insert the two tubes in the frame.
- Press the seat of the rollator up to arrest the frame tubes in position lock.
WARNING!
Make sure that the knobs is located into the holes.
Before use, always make sure that the rollator does not tend to close up
under the influence a small lateral force.
Be careful not to twist the brake cables when connecting the handlebar and wheels.
1.
Folding the rollator
Lift up the seat firmly pulling the straps in the middle of seat
2.
Installation of the handles and adjustable handles
Insert the handles into the frame. Simply depress the spring button and set to the desired height.
Repeat the opposite side and make sure that both handles are secure and set at the same height before
use. The rollator is equipped with height adjustable handles through the pins to meet all user needs.