8
Genuine OEM Parts 1.800.233.4823 www.morganolsonparts.com
9
USPS 2 Ton Delivery Vehicle 2016 - 2018 Models
CONFIDENTIAL
NOT
FOR DISTRIBUTION
CONFIDENTIAL
NOT
FOR DISTRIBUTION
CONFIDENTIAL
NOT
FOR DISTRIBUTION
CONFIDENTIAL
NOT
FOR DISTRIBUTION
Side Door Adjustment:
1.
Loosen all nuts on the top of the slotted upper door track.
2. Loosen the 3 screws fastening down the lower door track.
3. The rear holes of the lower door track are oversized to allow for adjustment. Only the rear
portion of the track can be adjusted. The forward hole of the lower track is not oversized
because the door must retain its forward position to ensure proper alignment when the
door is closed.
4. With the door closed and engaged in the forward strike, adjust the upper track for uni-
form lateral placement of the door in the forward post seal. Snug the forward bolt of the
upper door track.
5.
With the door open and engaged in the rear strike, the rear portion of the upper and low
-
er tracks can be adjusted laterally to ensure proper alignment with the rear striker.
6.
When the door is positioned, tighten a few of the fasteners in the upper and lower tracks.
Operate the sliding door to ensure that it slides and latches properly.
7.
When the door is operating properly, tighten all the remaining fasteners in the upper and
lower door tracks.
8. Replace any broken studs with .25 - 20x1.00 truss head screw.
9
See figure 1 on the following page.
Door Latch Adjustment:
1.
The door latches (strikers) and the mounting brackets provide for adjustment in a variety
of directions.
2. Once the door has been adjusted to slide smoothly, then adjust the strikers for proper
latch operation.
