6
7
TROUBLE SHOOTING
USER MAINTENANCE INSTRUCTIONS
This appliance requires little maintenance and contains no user-serviceable parts.
Any servicing requiring disassembly other than cleaning must only be performed by
a qualified appliance repair technician.
IMPORTANT!
1. Before cleaning or performing maintenance on the appliance, disconnect it from the
gas and power supply and allow it to cool before proceeding.
2. It is recommended to have the appliance cleaned regularly to extend its functionality.
3. Do not use steam equipment to clean the appliance.
CARE & CLEANING INSTRUCTIONS
1. Wash the enamelled parts and the glass top with warm water.
2. Do not use metal kitchen utensils or abrasive cleansers or corrosive cleansing agents
as this may damage the finishing.
3. Wash the removable parts of the burner frequently with warm water and mild
detergent, ensuring caked-on residues are removed.
4. Clean the ends of the electronic ignition device (applicable for cooktops with ignition
device) carefully and frequently. Make sure the gas holes are not clogged.
5. While still warm, clean the hobs with a damp cloth and rub with a little oil.
6. Rinse stainless steel parts with water and dry well as these can be stained if it
remains in contact with highly calciferous water or detergents containing phosphorus.
7. It is recommended to clean up the spills object after every cook.
GREASING THE TAPS
This procedure can only be performed by an authorized service technician as taps may be
clogged over long period of use and may be difficult to turn.
CARE & CLEANING
PROBLEM CAUSES SOLUTIONS
Failed Ignition
Power is not connected. Connect power.
High voltage wire leakage. Replace high voltage wire.
Ignition porcelain head leakage. Replace high voltage wire
Pulse ignitor is broken. Replace pulse ignitor
Microswitch connection is faulty. Replace/adjust microswitch.
Battery installation is faulty. Install battery correctly.
Incorrect distance between ignition Adjust to 5-6mm distance.
porcelain head and burner cap.
Gas supply is not connected. Reconnect gas supply.
Flame Failure –
Incorrect throttle position. Adjust throttle position
Device Open
Incorrect thermocouple position. Adjust thermocouple position
Valve Time Failure
Flame failure device malfunction. Replace flame failure device
Backfiring
Improper burner cap position. Adjust burner cap.
Burner leakage or throttle opens too Replace burner or adjust throttle.
wide.
Burner cap is upside down. Adjust burner cap.
Flameout
Throttle opens too wide. Adjust throttle.
Noise
Incorrect burner cap position. Adjust burner cap.
Throttle opens too wide. Adjust throttle.
