SPECIFICATIONS
4
5
MSI-GA221C(IM)150813_Layout 1 8/15/13 12:56 PM Page 3
KNOW YOUR WATER KETTLE
If you are using the kettle for the first time, it is recommended that you
should clean your kettle before use by boiling the Max capacity of water
once and then discarding the water. Wipe the surface with damp cloth.
NOTE: The max capacity of kettle is 1.0L.
BEFORE USING YOUR KETTLE
MODEL
MJK-1010L
RATED VOLTAGE / FREQUENCY
220-240V 50/60Hz
RATED WATTAGE
1000-1200W
SPECIFICATIONS
USING YOUR WATER KETTLE
1. Place the unit on the level surface.
2. To fill the kettle, remove it from the power base and open the lid by
pressing the lid release button, fill with the desired amount of water,
and then close the lid. Alternatively, the kettle may be filled through the
spout. The water level should not exceed MAX marks or sit below MIN
level. Too little water will cause the kettle switching off before the water
has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill
out of the spout when boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet. Press down the On/Off switch,
the indicator will light up. Then the kettle will start to boil the water, once
the water has being boiled the On/Off switch will be off automatically.
You can shut off the power by lifting the On/Off switch at any moment
during boiling water. If you want to boil water again, only press down
the On/Off switch directly to restart the kettle.
NOTE: Ensure that the On/Off switch is free of obstructions and the lid
is firmly closed, the kettle will not turn off if the switch is constrained or if
the lid is opening.
5. Lift the kettle from the power base and then pour the water.
NOTE: Operate carefully when pouring the water from your kettle as
boiling water may result in scald, besides, don’t open the lid while the
water in the kettle is hot.
6. The kettle will not re-boil until the On/Off switch is pressed down
again. The kettle may be stored on the power base when not in use.
NOTE: Always disconnect the power supply when not use.
