4
www.morganadvancedmaterials.com
Insert Registered Legal Entity name, address and number, or all other details as required to comply with regional regulations
4
RECOMMENDATIONS
Read this manual prior to installing the software and using the device for the first time. All instructions
included in the manual must be followed.
Remove any loose dirt/debris from the collector surface prior to taking a profile and always ensure that the
sensor head is clean before taking any readings as this could affect the results of the profile severely. Use a
clean, lint free cloth for this, for example, spectacle lens cleaning cloths
The sensor head is a highly accurate piece of equipment, and although constructed to withstand normal
handling, it should be treated with care at all times. The sensor should always be stored in its supplied
sleeve when not in use.
When recording a profile, the results will be more consistent when the sensor is mounted as radially as
possible (ideally ±1°) and when rotated in the direction as indicated in the figure below.
Under no circumstances should the sensor be clamped directly
–
it should always be fitted in a holder or
sleeve and the sleeve held in place with a clamp.
It is recommended that the sensor is calibrated every 12 months
–
this can either be done by sending your
MSPro14 to your local Morgan Sales office or directly to Morgan Advanced Materials Netherlands.
